meta data for this page
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
documentation:rack_mounting [2014/10/31 11:27] – vor | documentation:rack_mounting [2016/06/09 12:58] (current) – vor | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Rack mounting ====== | ====== Rack mounting ====== | ||
- | {{:developer:uart_cxp_30.jpg?300|}} | + | The Antares version of the RECS< |
+ | |||
+ | The following chapter is copied from the [[http:// | ||
+ | |||
+ | - Slide chassis member (smallest) is removable. Separate slide members by lifting left hand side lever up, and right hand side lever down. Keep slide chassis members with original outer members. | ||
+ | - Slide has front and rear adjustable EIA brackets. Attach front brackets to outer slide member using #8-32 machine screws by aligning access slots on brackets to outer member holes. Front brackets can be mounted flush or 1/2" [12.7 mm] back from front of slide based on user needs. | ||
+ | - Establish distance from front cabinet rail to rear cabinet rail and attach rear brackets to slide. **Do not** fully tighten rear bracket mounting screws until final adjustment is made. | ||
+ | - Insert removable locator pin into center hole of brackets. | ||
+ | - Slide will mount to various cabinet rails at various locations on side of chassis. See illustrations at right. | ||
+ | - Place slide into desired position and fully extend against EIA rails. Locator pins will support slide and bar nut while attaching screws. | ||
+ | - Attach slide to EIA rail with #10-32 screws and fasten with bar nuts. Once screws are secure, remove locator pins. Do not fully tighten screws until final adjustment is made. | ||
+ | - Mount slide chassis members (smallest) to the chassis. | ||
+ | - With cabinet members in the open or closed position, bring ball retainer to full forward position. Install chassis by engaging the slide members and close completely. **Locks will engage on initial insertion and must be released to fully close.** Check slide alignment by opening and closing the chassis. Any sign of binding indicates lateral stress or misalignment. | ||
+ | - Adjust slide position until movement is smooth. Tighten all screws and complete installation. | ||
+ | |||
+ | **NOTE:** | ||
+ | To remove chassis, lift the lever on the left hand slide up and the lever on the right hand slide down. | ||
+ | |||
+ | < | ||
+ | {{ : | ||
+ | < | ||
+ | {{ : | ||
+ | < | ||
+ | {{ : | ||
+ | < | ||
+ | {{ :documentation:rail_figure_4.png?direct& |