meta data for this page
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
documentation:opening_closing_the_case [2014/11/03 10:25] – mic | documentation:opening_closing_the_case [2014/11/12 09:31] (current) – mic | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Opening/ | ====== Opening/ | ||
- | To open the case first make sure, that **no heavy load** is on the modules. Because this can lead to an overheating when the top cover is removed. | + | To open the case first make sure, that **no heavy load** is on the modules. Because this can lead to overheating when the top cover is removed.\\ |
+ | Always make sure that no tools or any other stuff can fall into the case. | ||
===== Antares ===== | ===== Antares ===== | ||
+ | |||
+ | When opening the case watch out **not to touch the 230V** cables or connector block in the back that lead to the power supplies. This can result in a danagerous electric shock. | ||
+ | |||
==== Opening the case ==== | ==== Opening the case ==== | ||
- | First unscrew the M3 knurled screw at the top back of the Antares.\\ | + | First unscrew the M3 knurled screw (A) at the top back of the Antares. |
- | Then slide the cover back and carefully lift the cover so that the hooks don't get stuck and bend. | + | Then slide the cover back (B) and carefully lift the cover so that the hooks don't get stuck and bend. |
==== Closing the case ==== | ==== Closing the case ==== | ||
Place the cover onto the Antares so that the hooks fit into the holes in the chassis.\\ | Place the cover onto the Antares so that the hooks fit into the holes in the chassis.\\ | ||
- | Then slide the cover to the front while pushing the hooks downwards into the holes if they are stuck.\\ | + | Then slide the cover to the front (B) while pushing the hooks downwards into the holes if they are stuck.\\ |
- | At last tighten the M3 knurled screw at the top back of the Antares. | + | At last tighten the M3 knurled screw (A) at the top back of the Antares. |
+ | |||
+ | < | ||
===== Arneb ===== | ===== Arneb ===== | ||
==== Opening the case ==== | ==== Opening the case ==== | ||
+ | |||
+ | Unscrew the 14 (six on top, eight on the sides; marked red below) M3 screws using a T8 Torx screwdriver and lift the cover. | ||
==== Closing the case ==== | ==== Closing the case ==== | ||
+ | Place the cover on top of the Arneb and check if the screwholes of the cover align with the ones in the chassis.\\ | ||
+ | If this is not the case the cover is placed in the wrong direction. Tighten all 14 screws (marked red below) using a T8 Torx screwdriver. | ||
+ | |||
+ | < | ||
+ | {{ : | ||
+ | |||
+ | ===== Alasco ===== | ||
+ | |||
+ | **Do not open** the case of the Alasco.\\ | ||
+ | If you encounter a problem with the Alasco please contact your vendor. |