Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
documentation:extension_card_installation [2014/11/12 11:55]
mic [Extension card installation]
documentation:extension_card_installation [2014/11/14 10:43] (current)
mic
Line 20: Line 20:
  
 The Arneb can hold single slot cards. If the card is too long no node or netboard can be placed where the card is. There are grid plates available, that can be used to build a holding structure for the card onto. The Arneb can hold single slot cards. If the card is too long no node or netboard can be placed where the card is. There are grid plates available, that can be used to build a holding structure for the card onto.
-It is possible to install a dual slot card, if the heatsing is small enought ​not to touch the backplane.\\+It is possible to install a dual slot card, if the heatsing is small enough ​not to touch the backplane.\\
 An example of an extension card that requires the space of the netboard installed in an Arneb can be seen below. An example of an extension card that requires the space of the netboard installed in an Arneb can be seen below.
  
 <​imgcaption extension_card_arneb.jpg|>​{{ :​documentation:​extension_card_arneb.jpg?​nolink&​300 |Single slot graphics card in an Arneb}}</​imgcaption>​ <​imgcaption extension_card_arneb.jpg|>​{{ :​documentation:​extension_card_arneb.jpg?​nolink&​300 |Single slot graphics card in an Arneb}}</​imgcaption>​