meta data for this page
  •  

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
documentation:fan_replacement [2014/11/05 16:01] – [Antares] micdocumentation:fan_replacement [2014/11/14 09:46] (current) – mic
Line 2: Line 2:
  
 A fan that has damaged blades schould be **replaced immediately**, because the bearing will break very fast due to the imbalance and resulting vibrations.\\ A fan that has damaged blades schould be **replaced immediately**, because the bearing will break very fast due to the imbalance and resulting vibrations.\\
-When changing a fan on a working system be very carefull not to touch the blades or get any cables into the fans. Also watch out that the system is not overheating during the changing process.\\+When changing a fan on a working system be very carefull not to touch the blades or get any cables into the running fans. Also watch out that the system is not overheating during the changing process.\\ 
 +Watch out that the **plugs are correctly placed on the baseboard**. As a short circuit or misalignment of the pins will damage the baseboard.\\ 
 Open the case according to the [[documentation:opening_closing_the_case|Opening/closing the case]] chapter of this wiki. Open the case according to the [[documentation:opening_closing_the_case|Opening/closing the case]] chapter of this wiki.
 First disconnect the fan from its power source and make sure the cable is not stuck anywhere. First disconnect the fan from its power source and make sure the cable is not stuck anywhere.
Line 11: Line 13:
 ===== Antares ===== ===== Antares =====
  
-  - to remove the fan simply drag it out of the mounting plate diagonally. +  - To remove the fan simply drag it out of the mounting plate diagonally. 
-  - unscrew the anti-vibration-rubber from the broken fan with a PH2 screwdriver, and screw them diagonally onto the new fan so that the cable and airflow point in the right direction when installed. +  - Unscrew the anti-vibration-rubber from the broken fan with a PH2 screwdriver, and screw them diagonally onto the new fan so that the cable and airflow point in the right direction when installed. 
-  - stick the fan back into the mounting plate +  - Push the fan back into the mounting plate. 
-  - arrange the cable under the fans and connect it+  - Arrange the cable under the fans and connect it.
  
 <imgcaption fan_removal|>{{ :documentation:fan_removal.png?nolink&300 |Removing a fan from the Antares}}</imgcaption> <imgcaption fan_removal|>{{ :documentation:fan_removal.png?nolink&300 |Removing a fan from the Antares}}</imgcaption>
Line 21: Line 23:
 ===== Arneb ===== ===== Arneb =====
  
-  - unscrew the two screws that hold the fan to the chassis with a PH2 screwdriver +  - Unscrew the two screws that hold the fan to the chassis with a PH2 screwdriver. 
-  - replace the fan with a new one considering the airflow direction +  - Replace the fan with a new one considering the airflow direction. 
-  - tighten the two screws +  - Tighten the two screws. 
-  - plug the cable onto the baseboard+  - Plug the cable onto the baseboard.