Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
documentation:physical_interface [2016/12/14 16:22]
vor [Control panel]
documentation:physical_interface [2016/12/14 16:22] (current)
vor [LCD display]
Line 53: Line 53:
  
 ^  Display ​ ^ Description ^ ^  Display ​ ^ Description ^
-| {{:​documentation:​lcd_recs_box_rpu_192_168_13_50.png?​nolink|}} | Shows the IP address of the RPU | +| {{:​documentation:​lcd_recs_box_rpu_192_168_13_50.png?​nolink&288|}} | Shows the IP address of the RPU | 
-| {{:​documentation:​lcd_health_ok_10_psus_install.png?​nolink|}} | Displays the current health status of the RPU and the number of power supplies installed. | +| {{:​documentation:​lcd_health_ok_10_psus_install.png?​nolink&288|}} | Displays the current health status of the RPU and the number of power supplies installed. | 
-| {{:​documentation:​lcd_2_on_15_w_oe_load.png?​nolink|}}| Shows the numer of power supplies that are currenty on, and the power provided by the RPU. A percentage bar (10% steps) of the load is shown in the lower line. | +| {{:​documentation:​lcd_2_on_15_w_oe_load.png?​nolink&288|}}| Shows the numer of power supplies that are currenty on, and the power provided by the RPU. A percentage bar (10% steps) of the load is shown in the lower line. | 
-| {{:​documentation:​lcd_0_off_l_00001_e_1_on_r_00001_e.png?​nolink|}}| Shows the on/off status for each power supply (0=off 1= on). A dash (“-”) indicates power supplies that are not populated or where not found. “L” and “R” mark the orientation of the display and are shown as looking onto the front panel. |+| {{:​documentation:​lcd_0_off_l_00001_e_1_on_r_00001_e.png?​nolink&288|}}| Shows the on/off status for each power supply (0=off 1= on). A dash (“-”) indicates power supplies that are not populated or where not found. “L” and “R” mark the orientation of the display and are shown as looking onto the front panel. |
  
 ==== Power connectors ==== ==== Power connectors ====