meta data for this page
  •  

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
Next revisionBoth sides next revision
documentation:opening_closing_the_case [2014/11/03 14:02] – micdocumentation:opening_closing_the_case [2014/11/04 08:26] – mic
Line 1: Line 1:
 ====== Opening/closing the case ====== ====== Opening/closing the case ======
  
-To open the case first make sure, that **no heavy load** is on the modules. Because this can lead to an overheating when the top cover is removed.+To open the case first make sure, that **no heavy load** is on the modules. Because this can lead to overheating when the top cover is removed.
  
 ===== Antares ===== ===== Antares =====
 ==== Opening the case ==== ==== Opening the case ====
  
-First unscrew the M3 knurled screw (<color red>A</color>) at the top back of the Antares.\\ +First unscrew the M3 knurled screw (<color red>A</color>) at the top back of the Antares. It may be necessary to pull the Antares out of the rack further than the rails allow. To to this pull the Antares out until the rails lock in place, and then use the levers to the left and right (as described in [[documentation:rack_mounting|Rack mounting]]) to slide the Antares over the locking point. **But don't pull to far**, as the Antares could slip out of the rails!\\ 
 Then slide the cover back (<color orange>B</color>) and carefully lift the cover so that the hooks don't get stuck and bend. Then slide the cover back (<color orange>B</color>) and carefully lift the cover so that the hooks don't get stuck and bend.
  
Line 20: Line 20:
 ==== Opening the case ==== ==== Opening the case ====
  
-Unscrew the 14 (six on top; eight on the sides; marked red below) M3 screws using a T8 Torx screwdriver and lift the cover.+Unscrew the 14 (six on top, eight on the sides; marked red below) M3 screws using a T8 Torx screwdriver and lift the cover.
  
 ==== Closing the case ==== ==== Closing the case ====
  
 Place the cover on top of the Arneb and check if the screwholes of the cover align with the ones in the chassis.\\ Place the cover on top of the Arneb and check if the screwholes of the cover align with the ones in the chassis.\\
-If this is not the case the cover is placed in the wrong direction. Tighten all 14 screws (marked reb below) using a T8 Torx screwdriver.+If this is not the case the cover is placed in the wrong direction. Tighten all 14 screws (marked red below) using a T8 Torx screwdriver.
  
-<imgcaption arneb_cover_screws|Cover screws (red circle)>+<imgcaption arneb_cover_screws|Cover screws (red circle); the four screws on the right side are not shown>
 {{ :documentation:arneb_cover_screws.png?direct&450 |}}</imgcaption> {{ :documentation:arneb_cover_screws.png?direct&450 |}}</imgcaption>