meta data for this page
  •  

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revisionBoth sides next revision
documentation:opening_closing_the_case [2014/11/03 14:02] – micdocumentation:opening_closing_the_case [2014/11/03 14:07] – optical changes mic
Line 1: Line 1:
 ====== Opening/closing the case ====== ====== Opening/closing the case ======
  
-To open the case first make sure, that **no heavy load** is on the modules. Because this can lead to an overheating when the top cover is removed.+To open the case first make sure, that **no heavy load** is on the modules. Because this can lead to overheating when the top cover is removed.
  
 ===== Antares ===== ===== Antares =====
Line 20: Line 20:
 ==== Opening the case ==== ==== Opening the case ====
  
-Unscrew the 14 (six on top; eight on the sides; marked red below) M3 screws using a T8 Torx screwdriver and lift the cover.+Unscrew the 14 (six on top, eight on the sides; marked red below) M3 screws using a T8 Torx screwdriver and lift the cover.
  
 ==== Closing the case ==== ==== Closing the case ====
  
 Place the cover on top of the Arneb and check if the screwholes of the cover align with the ones in the chassis.\\ Place the cover on top of the Arneb and check if the screwholes of the cover align with the ones in the chassis.\\
-If this is not the case the cover is placed in the wrong direction. Tighten all 14 screws (marked reb below) using a T8 Torx screwdriver.+If this is not the case the cover is placed in the wrong direction. Tighten all 14 screws (marked red below) using a T8 Torx screwdriver.
  
-<imgcaption arneb_cover_screws|Cover screws (red circle)>+<imgcaption arneb_cover_screws|Cover screws (red circle); the four screws on the right side are not shown>
 {{ :documentation:arneb_cover_screws.png?direct&450 |}}</imgcaption> {{ :documentation:arneb_cover_screws.png?direct&450 |}}</imgcaption>