meta data for this page
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
documentation:baseboard_replacement [2014/11/03 15:56] – added a instructions mic | documentation:baseboard_replacement [2014/11/14 09:35] (current) – mic | ||
---|---|---|---|
Line 2: | Line 2: | ||
When removing a Baseboard always **work very carefully** and **do not bend** the baseboards **nor use greater force** to get them into place. | When removing a Baseboard always **work very carefully** and **do not bend** the baseboards **nor use greater force** to get them into place. | ||
- | Pay attention to the Newtork | + | Pay attention to the newtork |
+ | It is recommended to turn the systempower off when changing a baseboard. | ||
===== Com Express Baseboard ===== | ===== Com Express Baseboard ===== | ||
Line 8: | Line 9: | ||
Remove the two M2,5 screws (B) with a T8 Torx screwdriver from the mSATA drive, and the four M3 screws (A) with a 5,5mm hexagonal nut.\\ | Remove the two M2,5 screws (B) with a T8 Torx screwdriver from the mSATA drive, and the four M3 screws (A) with a 5,5mm hexagonal nut.\\ | ||
Then lift the baseboard a bit at the end where the fan connectores are. And while moving it a bit to the left and right gently pull the baseboard out of the connector on the backplane.\\ | Then lift the baseboard a bit at the end where the fan connectores are. And while moving it a bit to the left and right gently pull the baseboard out of the connector on the backplane.\\ | ||
- | Before plugging in a new baseboard make sure that there is a strong | + | Before plugging in a new baseboard make sure that there is a robust |
To plug the baseboard in procede the opposite way as removing it. | To plug the baseboard in procede the opposite way as removing it. | ||
- | < | + | < |
===== ARM Baseboard ===== | ===== ARM Baseboard ===== | ||
- | Remove the four M3 screws (marked red) with a T10 Torx screwdriver. It can be handy to use a T9 Torx screwdriver for the screw in the top left on the picture below when the Apalis modules are still in place. | + | The baseboard can be replaced when the Apalis modules are plugged in. And it is not recommended to remove the plasic module-holders. If an Apalis-holder is broken try to fix it with superglue **without removing** it from the baseboard.\\ |
+ | Remove the four M3 screws (marked red) with a T10 Torx screwdriver. It can be handy to use a T9 Torx screwdriver for the screw in the top right on the picture below, when the Apalis modules are still in place.\\ | ||
+ | Then lift the baseboard a bit at the end where the fan connectores are. And while moving it a bit to the left and right gently pull the baseboard out of the connector on the backplane.\\ | ||
+ | To plug the baseboard in proceed the opposite way as removing it. | ||
- | < | + | < |