meta data for this page
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | |||
documentation:sensors [2015/05/19 08:46] – vor | documentation:sensors [2016/11/03 14:05] (current) – removed vor | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Sensors ====== | ||
- | |||
- | Each Baseboard of the RECS< | ||
- | |||
- | ===== Locations ===== | ||
- | |||
- | The following pictures indicate the location of the various temperature sensors on the baseboards along with their indices in the management data. The golden finger contacts on the right side of the picture always point towards the backplane. | ||
- | |||
- | < | ||
- | |||
- | <WRAP center round info 60%> | ||
- | Please note that temperature sensor 1 on the ARM baseboard (near the four fan connectors) is somehow thermally connected to the voltage regulators (located between the four fan connectors). This results in high temperature of this sensor if the modules 1 and 2 are powered on and consuming a lot of electrical power. | ||
- | </ | ||
- | |||
- | < | ||
- | |||
- | ===== Assignment ===== | ||
- | |||
- | Depending on baseboard type and location, the Arneb RCU calculates inlet- and outlet temperature for each baseboards by averaging different temperature sensor readings. The following table shows which sensor(s) are used, where " | ||
- | |||
- | ^ Temperature ^ Type ^ Left ^ Right ^ | ||
- | | Inlet | CXP | 1 | 3 | | ||
- | | ::: | APLS | 1, 2 | 3, 4 | | ||
- | | Outlet | CXP | 3 | 1 | | ||
- | | ::: | APLS | 3, 4 | 1, 2 | | ||