meta data for this page
  •  

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
documentation:rpu_interface [2014/11/06 14:52] – krudocumentation:rpu_interface [2016/11/03 14:05] (current) – removed vor
Line 1: Line 1:
-====== RPU interface ====== 
  
-===== Front panel connectors ===== 
- 
-The Alasco power supply unit has the following items in its frontpanel: 
- 
-  * Two line display 
-  * One LAN port that connects to the internal colibri with the management software of the power supply 
-  *  
-===== LCD display ===== 
- 
-^  Display  ^ Description ^ 
-| <imgcaption lcd_recs_box_rpu_192_168_13_50|LCD IP screen> 
-{{:documentation:lcd_recs_box_rpu_192_168_13_50.png?nolink|}}</imgcaption> | Shows the IP address of the RPU | 
-| <imgcaption lcd_health_ok_10_psus_install|LCD health screen> 
-{{:documentation:lcd_health_ok_10_psus_install.png?nolink|}}</imgcaption> | Displays the current health status of the RPU and the number of power supplies installed. | 
-| <imgcaption lcd_2_on_15_w_oe_load|LCD load screen> 
-{{:documentation:lcd_2_on_15_w_oe_load.png?nolink|}}</imgcaption>| Shows the numer of power supplies that are currenty on, and the power provided by the RPU. A percentage bar (10% steps) of the load is shown in the lower line. | 
-| <imgcaption lcd_0_off_l_00001_e_1_on_r_00001_e|LCD installed power supplies> 
-{{:documentation:lcd_0_off_l_00001_e_1_on_r_00001_e.png?nolink|}}</imgcaption>| Shows the on/off status for each power supply (0=off 1= on). A dash (“-”) indicates power supplies that are not populated or where not found. “L” and “R” mark the orientation of the display and are shown as looking onto the front panel. | 
- 
-===== Power connectors ===== 
- 
-The Alasco has one male C19 jack on the back that can be connected to an 230V power outlet using a C20 cable. Connect this cable to an 16A fuse, as the Alasco can require up to 3600W.\\ 
-There are nine 12V plugs in the back, that can be connected to one or more Arnebs via the coded connectors. The upper male plug is the (-) pin and the bottom female plug is the (+) pin.