meta data for this page
  •  

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
documentation:management_webgui [2014/11/14 10:02] – micdocumentation:management_webgui [2016/11/03 13:56] (current) – removed vor
Line 1: Line 1:
-====== Management WebGUI ====== 
- 
-The Management Web****GUI is established on every RECS<sup>(r)</sup>%%|%%Box unit. Accessible by any known browser on the assigned IP address and the default port 80. The following views are dependent on the device and assembly. 
- 
-In general these symbols have the following meaning on every page: 
- 
-|{{ :documentation:statusok.png?nolink |}}|Everything is OK. Also indicated by a green line in a graph.| 
-|{{ :documentation:statuswarning.png?nolink |}} |Warnung. Something is wrong, but the system is still fully functional. The system has to be checked so the problem doesn't get worse. Indicated by a yellow line in a graph.| 
-|{{ :documentation:statuscritical.png?nolink |}} |Critical Error. The system must be checked immediately and maybe has to be shut down to prevent hardware damage. indicated by a red line in a graph.| 
- 
-Figure 1 shows the first call of the Management Web****GUI. It is organized into three columns. The first is on the left-hand side and contains the following: 
- 
-[[documentation:management_webgui#overview|Overview:]] General overview of all managed RCU<sup></sup>s, RPU<sup></sup>s, installed nodes and health status\\ 
-[[documentation:management|Management:]] Selection of every managed RCU and RPU in the rack with a sensor view button for the Arneb\\ 
-[[documentation:global_settings|Global settings:]] IP filter and firmware update\\ 
-[[documentation:log_viewer|Log:]] Logs from the management software about system health and java messages. The logs can be downloaded as a zipfile\\ 
- 
-The second colum contains the buttons and sliders to manipulate the system. While the third colum is mostly for history information like power usage and temperature graphs. 
- 
-===== Overview ===== 
- 
-All units that are installed in the rack and that are managed by the software are summarized on this page. 
-The total power usage is summed up over all managed units. 
- 
-<imgcaption web-gui-overview|> 
-{{ :documentation:web-gui-overview.jpg?direct&500 |Management Overview}}</imgcaption> 
-