meta data for this page
  •  

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
documentation:management_webgui [2014/11/13 09:51] – micdocumentation:management_webgui [2016/11/03 13:56] (current) – removed vor
Line 1: Line 1:
-====== Management WebGUI ====== 
-The Management WebGUI is established on every RECS<sup>(r)</sup>%%|%%Box unit. Accessible by any known browser on the assigned IP address and the default port 80. The following views are dependent on the device and assembly. 
- 
-Figure 1 shows the first call of the Management WebGUI. It is organized into three columns. The first is on the left-hand side and contains the following: 
- 
-  * Overview: General overview of all managed RCUs, PRUs, installed nodes and health status 
- 
-<imgcaption web-gui-overview|> 
-{{ :documentation:web-gui-overview.jpg?nolink&500 |Management Overview}}</imgcaption> 
- 
-  * Managemend: Selection of every managed RCU and RPU in the rack with a sensor view button for the Arneb 
- 
-<imgcaption web-gui-management|>{{ :documentation:web-gui-management.jpg?nolink&500 |Rack view of the managed units}}</imgcaption> 
- 
-  * Global settings: IP filter and firmware update 
- 
-<imgcaption web-gui-global_settings|>{{ :documentation:web-gui-global_settings.jpg?nolink&500 |Golobal settings tab}}</imgcaption> 
- 
-  * Log: Logs from the management software about system health and java messages. The logs can be downloaded as a zipfile 
- 
-<imgcaption image1|>{{ :documentation:web-gui-log-standart_view.jpg?nolink&500 |Log page}}</imgcaption> 
- 
-The second colum contains the buttons to manipulate the system (exept for the log tab). While the third colum is mostly for information like power usage and temperature graphs. 
-