meta data for this page
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| doc_urecs:server_installation [2024/10/01 14:39] – [Nvidia Jetson Xavier NX module] vor | doc_urecs:server_installation [2024/10/01 14:43] (current) – [M.2 card installation] vor | ||
|---|---|---|---|
| Line 25: | Line 25: | ||
| ===== M.2 card installation ===== | ===== M.2 card installation ===== | ||
| + | Both M.2 cards on the top side of the u.RECS can be connected to both the SMARC and the Nvidia Jetson NX module. It is configurable via the different COM Bricks. The M.2 card on the down side of the u.RECS is always connected to the Nvidia Jetson NX module. | ||
| + | |||
| + | In general, installing an M.2 card is easy. Just gently insert the card in an angle of approximately 20°, push it down and use the M2 screws to fasten the M.2 card. | ||
| ===== Fan replacement ===== | ===== Fan replacement ===== | ||
| A fan that has damaged blades or any other kind of damage schould be **replaced immediately**. Fans can only be changed opening the u.RECS chassis. Please power down the whole system and disconnect power to not risk any damage due to shortcuts etc. | A fan that has damaged blades or any other kind of damage schould be **replaced immediately**. Fans can only be changed opening the u.RECS chassis. Please power down the whole system and disconnect power to not risk any damage due to shortcuts etc. | ||