meta data for this page
  •  

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
Next revisionBoth sides next revision
documentation:fan_replacement [2014/11/05 13:32] micdocumentation:fan_replacement [2014/11/05 16:01] – [Antares] mic
Line 5: Line 5:
 Open the case according to the [[documentation:opening_closing_the_case|Opening/closing the case]] chapter of this wiki. Open the case according to the [[documentation:opening_closing_the_case|Opening/closing the case]] chapter of this wiki.
 First disconnect the fan from its power source and make sure the cable is not stuck anywhere. First disconnect the fan from its power source and make sure the cable is not stuck anywhere.
 +
 +<imgcaption fan_connectors_bb_cxp|>{{:documentation:Fan_connectors_bb_cxp.png?nolink&300|Fan connectors on an CXP baseboard}}</imgcaption>
 +<imgcaption fan_connectors_bb_apls|>{{:documentation:Fan_connectors_bb_apls.png?nolink&300|Fan connectors on an ARM baseboard}}</imgcaption>
  
 ===== Antares ===== ===== Antares =====
  
   - to remove the fan simply drag it out of the mounting plate diagonally.   - to remove the fan simply drag it out of the mounting plate diagonally.
-  - unscrew the anti-vibration-rubber from the broken fan, and screw it diagonally onto the new fan so that the cable and airflow point in the right direction when installed.+  - unscrew the anti-vibration-rubber from the broken fan with a PH2 screwdriver, and screw them diagonally onto the new fan so that the cable and airflow point in the right direction when installed.
   - stick the fan back into the mounting plate   - stick the fan back into the mounting plate
   - arrange the cable under the fans and connect it   - arrange the cable under the fans and connect it
 +
 +<imgcaption fan_removal|>{{ :documentation:fan_removal.png?nolink&300 |Removing a fan from the Antares}}</imgcaption>
 +<imgcaption antares_fan_location|>{{ :documentation:antares_fan_location.png?direct&300 |Affinity of fans to the connectors on the baseboards}}</imgcaption>
  
 ===== Arneb ===== ===== Arneb =====
 +
 +  - unscrew the two screws that hold the fan to the chassis with a PH2 screwdriver
 +  - replace the fan with a new one considering the airflow direction
 +  - tighten the two screws
 +  - plug the cable onto the baseboard