meta data for this page
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | |||
documentation:rack_mounting [2016/06/09 12:55] – vor | documentation:rack_mounting [2016/06/09 12:58] (current) – vor | ||
---|---|---|---|
Line 5: | Line 5: | ||
The following chapter is copied from the [[http:// | The following chapter is copied from the [[http:// | ||
- | 1. Slide chassis member (smallest) is removable. Separate slide members by lifting left hand side lever up, and right hand side lever down. Keep slide chassis members with original outer members. | + | - Slide chassis member (smallest) is removable. Separate slide members by lifting left hand side lever up, and right hand side lever down. Keep slide chassis members with original outer members. |
- | + | | |
- | 2. Slide has front and rear adjustable EIA brackets. Attach front brackets to outer slide member using #8-32 machine screws by aligning access slots on brackets to outer member holes. Front brackets can be mounted flush or 1/2" [12.7 mm] back from front of slide based on user needs. | + | |
- | + | | |
- | 3. Establish distance from front cabinet rail to rear cabinet rail and attach rear brackets to slide. **Do not** fully tighten rear bracket mounting screws until final adjustment is made. | + | |
- | + | | |
- | 4. Insert removable locator pin into center hole of brackets. | + | |
- | + | | |
- | 5. Slide will mount to various cabinet rails at various locations on side of chassis. See illustrations at right. | + | |
- | + | | |
- | 6. Place slide into desired position and fully extend against EIA rails. Locator pins will support slide and bar nut while attaching screws. | + | |
- | + | ||
- | 7. Attach slide to EIA rail with #10-32 screws and fasten with bar nuts. Once screws are secure, remove locator pins. Do not fully tighten screws until final adjustment is made. | + | |
- | + | ||
- | 8. Mount slide chassis members (smallest) to the chassis. | + | |
- | + | ||
- | 9. With cabinet members in the open or closed position, bring ball retainer to full forward position. Install chassis by engaging the slide members and close completely. **Locks will engage on initial insertion and must be released to fully close.** Check slide alignment by opening and closing the chassis. Any sign of binding indicates lateral stress or misalignment. | + | |
- | + | ||
- | 10. Adjust slide position until movement is smooth. Tighten all screws and complete installation. | + | |
**NOTE:** | **NOTE:** |