meta data for this page
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Last revisionBoth sides next revision | ||
documentation:compute_module_installation [2014/11/05 09:43] – added a list for CXP installation mic | documentation:compute_module_installation [2014/11/11 09:06] – mic | ||
---|---|---|---|
Line 6: | Line 6: | ||
===== Com Express module ===== | ===== Com Express module ===== | ||
- | Before installing a Com Express module check if the RAM is installed, and that the heatspreader is correctly mounted, and depending on the module if all thermal pads are in place. Also the orientation of the heatsink fins has to follow the airflow trough the case. If it is an Antares the fins have to point from the front to the back. In an Arneb case they have to point from side to side.\\ | + | Before installing a Com Express module check if the RAM is installed, and that the heatspreader is correctly mounted, and depending on the module if all thermal pads are in place. Also the orientation of the heatsink fins has to follow the airflow trough the case. If it is an Antares the cooling |
The screwholes where the module lays on the spacer bolts (8mm in height) have to be free. Or smaller spacer bolts (5mm high) have to be installed.\\ | The screwholes where the module lays on the spacer bolts (8mm in height) have to be free. Or smaller spacer bolts (5mm high) have to be installed.\\ | ||
- When the module is ready to be plugged in place the two holes next to the Com Express connector over the corresponding spacer bolt. Then slide the outer CXP connector into the outer connector on the baseboard. Do this while tilting the module a bit, so that only the outer connector slides in | - When the module is ready to be plugged in place the two holes next to the Com Express connector over the corresponding spacer bolt. Then slide the outer CXP connector into the outer connector on the baseboard. Do this while tilting the module a bit, so that only the outer connector slides in | ||
Line 14: | Line 14: | ||
< | < | ||
- | When starting the module for the first time after installation, | + | When starting the module for the first time after installation, |